Materials: vernier computer embrasure Meter Stick Masking Tape lumberjack Pro 2 Vernier Photogates Ramp 1 Marble Computer Procedures: Set up a ramp at an go of about 10 degrees so that the ball will nestle off, then bank account about 10cm on the table and fall off. Connect the photo gates to DIG1 and DIG2. Then, set up the photo gates 8 to 10cm apart except still allowing the ball to roll by dint of with(predicate) them when it goes off the ramp then falls off the table. affect sure that the photogate plugged into D IG1 is closest to the ramp, but not on it. M! ark a point on the ramp to roll the ball from each time. Roll the ball down the ramp, through the photo gates, and catch the ball before it hits the ground. Open the lodge 08 projectile motion on fellow Pro. Enter the distance in steps between the photogates. note this using a meter stick. Hit collect and roll the marble down the ramp to see if the photo gates are working. Hit stop. Then, hit collect and roll the marble...If you want to get a integral essay, order it on our website: OrderEssay.net
If you want to get a full information about our service, visit our page: write my essay
No comments:
Post a Comment
Note: Only a member of this blog may post a comment.